Tree removal can be quite dangerous and even life-threatening. It really is never recommended to eliminate a tree on your own unless this can be a small one that you are confident it is possible to handle safely. Otherwise, tree removal should be left in the hands of professionally-trained and equipped tree service contractors. When you have a tree on your own property that is fairly small, but must be removed, you can possible do-it-yourself with the right tools, knowledge, and planning.
Tree Removal Preparation
Proper preparation for small tree removal involves gathering all your needed supplies, in addition to, a comprehensive inspection of the tree. Look to see if the tree leans a proven way or another, and plan an escape route in case it does not fall how you expect it to fall. Also, examine whether there are any obstacles in virtually any direction of the tree, including vehicles, structures, and other trees. If you are sure there is enough safe clearance for the tree to fall, then you can move on to gathering your equipment and tools. This includes:
Safety Gear (Utility gloves, goggles, hard hat, steel toe boots, etc.)
Chainsaw
Ax or Hacksaw
Ladder
Rope
Wedges
First Aid Kit
To Remove a Tree
Once you have all of your equipment and supplies, you may get started removing the tree. First, use your ax to knock on the bark several times, and in a few different places, to learn how solid or hollow the tree is. Finding a less dense area to cut will undoubtedly be easier. Next, Tree Services Barrow In Furness which side of the tree you would like to make your cut. Turn to see where the tree naturally leans; it is best to cut a tree in the direction where it wants to naturally fall. Be sure the area where the tree drops is level so the tree does not roll or bounce after it falls.
Make a horizontal cut at hip-height, and about 1/3rd in to the tree. Do this on the side of the tree where you want it to fall. If you need the tree to fall to the right, you must cause you to cut on the same side so it falls inward, towards the cut. The tree will fall perpendicular to your horizontal cut. Your second cut should create a wedge into the tree. So make the next cut at an angle from the original cut. It should appear to be a lemon wedge.
Your third cut is named a back cut, and is should be made on the opposite side of one's wedge cut. This cut can make the tree fall over on the side of one's wedge cut. Make it about 1.5 inches above the wedge cut, so when thick as possible. Also you can use a wedge to avoid the tree from settling onto the chainsaw. Add more wedges as necessary until the tree begins to fall. Then run! But usually do not turn your back on the tree as it falls.